T-junction for tray vertical 50x300mm up with 90 degree bend "PLUS" HD85 KM PL18215 KM SYSTEM

To ensure the specified bending radii of the cable route during installation, a vertical T-bend upwards of the "PLUS" series is used. The element design is applicable for upward route diversion, while rotating the open part of the metal tray around its axis by 90 degrees. It is recommended to use the element with a metal sheet tray of the same series with a width of 300 mm and a side height of 50 mm. The product is hot-dip galvanized according to GOST 9.307-2021 and is used for installation in high-humidity and low-pollution indoor environments, outdoors, and in low-corrosive environments, in accordance with GOST 15150-69. The T-bend is easily installed using fasteners. Special connecting tabs on the section body ensure the necessary rigidity of the joint assembly and the integrity of the route.