T-shaped tray bend, vertical 50x50mm up with 90deg route turn "PLUS" HD85 KM PL18217 KM SYSTEM

To ensure the specified bending radii of the cable route during installation, a vertical upward T-junction of the "PLUS" series is used. The design of the element is applicable for routing the path upwards by rotating the open part of the metal tray around its axis by 90 degrees. It is recommended to use the element with a metal sheet tray of the same series with a width of 50 mm and a side height of 50 mm. The product is hot-dip galvanized according to GOST 9.307-2021 and is used for installation in high-humidity and low-pollution indoor environments, outdoors, and in low-corrosive environments, in accordance with GOST 15150-69. The T-junction is easy to install using fasteners. Special connecting tabs on the section body ensure the necessary rigidity of the joint and the integrity of the route.