T-shaped bend for tray, vertical down 50x50 steel 1mm TDV50-50 KM LO6717 SYSTEM KM

The use of shaped products solves the task of rapid design and installation of cable management systems. The BASE SERIES vertical downward T-tee allows for maintaining the specified bending radii of the cable route during installation. This product modification is used to divert the route downwards. The element is recommended for use with a metal sheet tray of the same series with a width of 50 mm and a side height of 50 mm. The product is made of galvanized steel using the Sendzimir method. It is intended for use in locations preferably with a dry climate, indoors, and in mildly aggressive environments, in accordance with GOST 15150-69. The T-tee is easily installed using fasteners. Special connecting tabs on the section body ensure the necessary rigidity of the butt joint and the integrity of the route.