T-shaped tray bend vertical up with 90deg. route turn 500x50 steel 1mm "PLUS" TDNplus90-50-500 HD KM PL3694 KM SYSTEM

To ensure the specified bending radii of the cable route during installation, a "PLUS" series vertical T-bend upwards is used. The element design is applicable for diverting the route upwards, while rotating the open part of the metal tray around its axis by 90 degrees. It is recommended to use the element with a metal sheet tray of the same series with a width of 500 mm and a side height of 50 mm. The product is hot-dip galvanized according to GOST 9.307-2021 and is used for installation in high-humidity and low-pollution indoor environments, outdoors, and in low-corrosive environments, in accordance with GOST 15150-69. The T-bend is easily installed using fasteners. Special connecting flaps on the section body provide the necessary rigidity of the joint assembly and the integrity of the route.