Smoke fire detector IPDL-264/1-75-R3 (IP 212-264/10) (software version: 2.2) Rubezh Rbz-342261

IPDL-264/1- R3 - The detector is designed to operate as part of an addressable fire alarm system together with the addressable fire alarm control panel (PPCU) 011249-2-1 "Rubezh-2OP" prot.R3 (hereinafter PPCU) and addressable device controllers "Rubezh-KAU1" prot.R3, "Rubezh-KAU2" prot.R3. The detector's power supply and information exchange are carried out via the addressable communication line (ALC) and occupies one address. The device consists of an emitter unit and a receiver unit located in one housing, and a reflector installed on the opposite side of the protected area. Together they form an IR beam, the attenuation of which the device uses to detect the presence of smoke. The signal from the emitter passes through the controlled medium, is reflected from the reflector, and is captured by the receiver. In the event of a fire, smoke from the fire source rises to the ceiling, and the smoke-filled medium causes attenuation of the optical beam. In the receiver, the attenuated signal level is compared with the signal level obtained during setup and received as a signal corresponding to an optically clear medium. As soon as the ratio reaches the set threshold, a "Fire" signal is generated, which is transmitted to the PPCU via the ALC line. The detector can be produced in the following versions: IPDL-264/1-50 - R3; IPDL-264/1-75 - R3; IPDL-264/1-100 - R3, Where the values -50, -75, or -100 represent the maximum distance between the emitter and the reflector.