T-shaped vertical bend for tray 100x200mm upwards with 90 degree route turn "PLUS" HD85 KM PL18207 KM SYSTEM

To ensure the specified bending radii of the cable route during installation, a vertical upward T-junction of the "PLUS" series is used. The design of the element is applicable for routing the path upwards by rotating the open part of the metal tray around its axis by 90 degrees. It is recommended to use the element with a metal sheet tray of the same series with a width of 200 mm and a side height of 100 mm. The product is hot-dip galvanized according to GOST 9.307-2021 and is used for installation in high-humidity and low-pollution indoor environments, outdoors, and in low-corrosive environments, in accordance with GOST 15150-69. The T-junction is easily installed using fasteners. Special connecting tabs on the section body ensure the necessary rigidity of the butt joint and the integrity of the route.