T-shaped tray bend vertical 100x500mm up with 90deg route turn "PLUS" HD85 KM PL18210 KM SYSTEM

To ensure the specified bending radii of the cable route during installation, the "PLUS" series vertical upward T-bend is used. The design of the element is applicable for diverting the route upwards, while rotating the open part of the metal tray around its axis by 90 degrees. It is recommended to use the element with a metal sheet tray of the same series with a width of 500 mm and a side height of 100 mm. The product is galvanized by hot-dip method according to GOST 9.307-2021 and is used for installation in rooms with high humidity and low pollution, outdoors, and in low-corrosive environments, in accordance with GOST 15150-69. The T-bend is easily mounted using fasteners. Special connecting tabs on the section body ensure the necessary rigidity of the butt joint and the integrity of the route.